Vai al contenuto
Home » Attivare wps modem tim

Attivare wps modem tim

Attivare wps modem tim

Como desabilitar a função wps do roteador

Introdotto nel 2007 dalla Wi-Fi Alliance, il punto del protocollo è quello di consentire agli utenti domestici che sanno poco di sicurezza wireless e possono essere intimiditi dalle opzioni di sicurezza disponibili per impostare Wi-Fi Protected Access, oltre a rendere facile l’aggiunta di nuovi dispositivi a una rete esistente senza inserire lunghe frasi di accesso. Wi-Fi Protected Setup permette al proprietario dei privilegi Wi-Fi di bloccare altri utenti dall’uso del loro Wi-Fi domestico. Il proprietario può anche permettere alle persone di usare il Wi-Fi. Questo può essere cambiato premendo il pulsante WPS sul router domestico.[1]
Un’importante falla di sicurezza è stata rivelata nel dicembre 2011 che colpisce i router wireless con la funzione WPS PIN, che la maggior parte dei modelli recenti hanno abilitato per default. La falla permette ad un attaccante remoto di recuperare il PIN WPS in poche ore con un attacco di forza bruta e, con il PIN WPS, la chiave pre-condivisa (PSK) WPA/WPA2 della rete.[2] Gli utenti sono stati invitati a disattivare la funzione PIN WPS,[3] anche se questo potrebbe non essere possibile su alcuni modelli di router.[4]
In cui un PIN deve essere letto da un adesivo o da un display sul nuovo dispositivo wireless. Questo PIN deve poi essere inserito presso il “rappresentante” della rete, di solito l’access point della rete. In alternativa, un PIN fornito dal punto di accesso può essere inserito nel nuovo dispositivo. Questo metodo è la modalità di base obbligatoria e tutto deve supportarla. La specifica Wi-Fi Direct sostituisce questo requisito affermando che tutti i dispositivi con una tastiera o un display devono supportare il metodo PIN.[5]

Connect canon printer to wi-fi network or router

FrancYescO13-09-2020, 18:54I guess most of the “hidden features” come out by doing the unlock for all operators, which as they did with other modems I guess appears only after a reset and only if it is not connected to a TIM line
I had misunderstood. I did several tests, the correct configuration should be the one described in the attached image. However it doesn’t work, probably due to some other setting we don’t have access to.
In my opinion mdoem comparisons between different users have little sense because the hooked carrier and Wifi range are very affected by their specific conditions that are completely different from those of any other user.
In my opinion the comparisons between mdoem between different users make little sense because hooked carrier and Wifi range are very affected by their own specific conditions that are completely different from those of any other user.
Well, let’s say that with regard to the hooked carrier, certain types of behavior could be inherent in the chipset type and then occur in the same way even on different lines, in any case it is indicative feedback that at the statistical level can always be useful.

Tim hub

Important! If an answer is given to your question, it is useful for the giver of the answer to know if it helped you (or not)! So we ask you to respond to an answer as well.
You will receive the manual by email within a few minutes. If you did not receive an email, you probably entered a wrong email address or your mailbox is too full. It is also possible that your internet provider has a maximum size per email. Because a manual is sent with the email, it is possible that the email is larger than allowed by your provider.
If you have not received your email with manual within 15 minutes, it is possible that you have entered a wrong email address or that your email provider has set a maximum size per email that is smaller than the size of the manual.